As I was working with my own glue heat gun in the shop, the trigger that pushes the solid glue stick inside the gun broke. I had to push it by hand to finish the job. After the repair job was done, I had to open it and see what happened inside.

glue gun repair

It is a very old one and I was ready to buy a new one but why do that if it can be fixed.

fix glue gun

The black trigger was loose and it could not push the glue stick through.




As I took the screws off the body of the heat gun I was able to see inside. The problem was seen right away and a solution to the problem already in mind.

repair glue gun

The piece on this was broken and was shattered to pieces. I cleaned up the hole and came up with an idea to restore this old heat gun back to its former glory.

glue gun repairing

This is the other side of the broken part found in the heat gun. I cleaned the hole and look what I did.




It was actually very easy and simply solution to the problem.

how to repair glue gun

I have used a screw, a nut and two washers to hold it from both side and I put them together. The key here is to keep the screw and nut a little bit loose to give it some flexibility to keep the trigger moving back and forth. The result was amazing.

It took me only a few minutes to fix it. It did not cost me anything and it actually saved me some money off buying a new one. Although it was an old one but it was a very good quality one and it was worth saving. Mission accomplished.

waleed

This article was prepared for you by Waleed Rishmawi, one of our ‘Master Authors’ and currently working in the Bethlehem area of Palestine repairing electrical and electronic equipment.




P.S- Do you know of any your friends who would benefit from this content that you are reading now? If so, forward this website to your friends or you can invite your friends to subscribe to my newsletter for free in this Link.

Note: You can check his previous repair articles in the link below:

https://www.electronicsrepairfaq.com/positive-and-positive-terminals-on-a-welding-machine-replaced

 

About

Jestine Yong works as an Electronics Repair Lecturer in Kuala Lumpur Malaysia and his training website is http://www.NoahtechElectronicsTraining.com. You can check out his repair blog at http://www.JestineYong.com

5 comments on “How To Repair A Glue Gun

  1. Albert van Bemmelen says:

    You probably also kept the screw electrical insulated from the outside to prevent getting electrocuted in case the heatercoil wires touch the screw.

  2. Robert Calk says:

    Good job, Waleed. Saving money is a good thing.

  3. Henrique Jorge Guimarães Ulbrich says:

    Not just electronics. One real professional actually have to deal too with mechanics, optics, chemistry, economy, public relations and so on…

  4. Auth Zsigmond says:

    Ügyes vagy. Sajnos nekem is vannak problémás ragasztó pisztolyaim, a fűtőbetét rossz bennük, és sehol sem tudok beléjük vásárolni, itt Magyarországon. De még kínai ajánlatot sem láttam még sehol.
    ==========================

    Clever. Unfortunately, I also have problem-free glue pistols, the heating element is bad in them and I can not buy them anywhere in Hungary. But I have not even seen any Chinese offer anywhere.

  5. veeraa says:

    very usefull
    Thanks

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.